Exmoor Trim worked with a UK based tooling specialist to produce a set of precision injection mould tools that ensure the accuracy and consistency of each part.
The Defender LT77 Defeater three-piece kit includes a seat box cover, a one-piece floor & transmission tunnel mat, and center bulkhead section. The main seat box section has access flaps for the battery box and ECU box with moulded latch covers.
Minimal trimming is required as all the standard bolt points and access flaps are pre-cut into the seat box. Any areas that will need to be cut out on installation are clearly marked on the reverse of the mat and easily trimmed out with a sharp knife.
The LT77 Defeater Barrier Mat is suitable for 90, 110 & 130 Defenders fitted with the LT77 gearbox, except early NAS Defender 90s that had the LT77S. The Defeater Barrier Mat is not suitable for V8 Vehicles.
The LT77 matt set is intended to be used with the standard moulded rubber gear gaiter fitted to the vehicle and does NOT come with gear & handbrake gaiters.
A new set of seat mounting bolts and spacers to go under the seat runners are included in the kit.
Installation is a straightforward DIY job.
Key Features
- Noise suppression
- Vibration damping
- Easy to clean
- Suitable for use in all environments
- Water repellent
- Abrasion resistant
- Thermal Insulation
- Easy to install with minimal tools
- Suitable for Left or Right hand drive vehicles
- Suitable for 90, 110 & 130 vehicles with an LT77 gear box
- Can be used in conjunction with other soundproofing systems with up to 3mm thickness.
FITS:
Defender 90, 110 & 130 with the LT77 gearbox.
300tdi models with the LT77 gearbox
Not suitable for V8 Vehicles
Additional Images:
Fits These Vehicles:
| Model: | Notes: |
|---|
| Defender 90 | LT77 |
| Defender 110 | LT77 |
| Defender 130 | LT77 |